I will eventually have a long process that validates a couple of hundred fields. I will do this by creating processes that validate a section at a time. So I've created an action on a form that starts a process. The process it starts will call a number of processes to complete the whole validation process. I find that if I start a process directly, the process works normally. When I start the same process from another process, I just get a "process complete" message when clearly the chained process did not run.
Am I doing this correctly?
Chaining Processes
I'll do that. Here's what I get from the log. When I start the process directly, it clearly shows that the rule failed (what I expect) and then does what it's supposed to do.
When I start the process from another process, it indicates that the attribute(s) being evaluated could not be resolved. To me, it's as if the object is no longer in context this way.
Hmmm.
When I start the process from another process, it indicates that the attribute(s) being evaluated could not be resolved. To me, it's as if the object is no longer in context this way.
Hmmm.
I have a similar issue -
When calling a 2nd process from an initial process, the BO which was in context in the initial process cannot be referenced by the 2nd process. It seems to be not in context as far as the 2nd process is concerned. My understanding is that the BO should remain in context for other processes to use.
Can anyone clarify this ?
Peter
When calling a 2nd process from an initial process, the BO which was in context in the initial process cannot be referenced by the 2nd process. It seems to be not in context as far as the 2nd process is concerned. My understanding is that the BO should remain in context for other processes to use.
Can anyone clarify this ?
Peter
Still having some trouble -
My initial process uses two BOs, my 2nd process uses the same two BOs.
I've created Process Inputs for the 2nd process naming the two BOs and have referenced them in the code of the initial process which calls the 2nd process (USING Customer,CustomerID).
However, I am now receiving an 'Internal Error' message and the process cancels completely.
I think I'm passing the BOs properly. What could the error message mean ?
Peter
My initial process uses two BOs, my 2nd process uses the same two BOs.
I've created Process Inputs for the 2nd process naming the two BOs and have referenced them in the code of the initial process which calls the 2nd process (USING Customer,CustomerID).
However, I am now receiving an 'Internal Error' message and the process cancels completely.
I think I'm passing the BOs properly. What could the error message mean ?
Peter